1. According to the regulations in the machine lubrication diagram, add oil to each oil cup lubrication and manual lubrication points as required.
2. Roll the plate according to the parameters specified by the plate rolling machine, the thickness of the plate is 20mm, the maximum length is 2500mm, and the yield limit of the plate material is less than 250Mpa.
3. After the power is turned on, carry out the forward and reverse directions of the lower roller and the lifting and lowering of the upper roller, and check whether there is any abnormal stuck phenomenon in each movement.
4. Strictly operate according to the coil processing procedures and operation methods. When the upper roller is lifted to the limit position, great attention should be paid to the safe operation of the equipment.
5. When the main drive stops, the upper roller can be lifted and lowered, the overturned bearing can be tilted and reset, and the upper roller can be lifted.
6. During operation, if any abnormal phenomena such as irregular noise and impact are found, stop the machine immediately for inspection.
7. During the operation, all personnel should coordinate with each other, obey the command of the person in charge of the rolling plate, and it is forbidden to start the machine without a password.
8. When rolling the plate, pay great attention to the pressing of the hand by the steel plate and the rolling of the steel plate together.
9. Be careful not to collide with the machine when lifting the steel plate or reel with a crane.
